Scania ABS DTC 293 TC control

ABS Anti-lock Braking System · Scania

Code 293 (decimal). Some diagnostic tools show it in hexadecimal as 0125.

In short

The current in the circuit has been below the permitted level.

Applies to: ABS E

What does Scania ABS fault code 293 mean?

The current in the circuit has been below the permitted level.

What causes Scania DTC 293?

Damage to the TC valve or its wiring has caused an open circuit. The fault code can also be generated in vehicles without TC if the ABS control unit was incorrectly configured as with TC.

How does the system react?

TC and hill hold function cease to function, if applicable.

How to fix Scania ABS fault code 293?

  1. Check the wiring.
  2. The resistance between pin B7 and B16 must be 30-42 ohms.
  3. If the vehicle does not have TC, the incorrect TC configuration must be reset before the fault code can be deleted.
  4. Carry this out under the Adjustment tab.

This information is for guidance only. Always follow the manufacturer workshop manual and safety procedures; if in doubt, contact an authorised workshop.

Code 293 in other Scania systems

Compare code 293 in every system →