Applies to: AMP1 (AMP)
What does Scania AMP fault code 1025 mean?
The external amplifier indicates a memory fault.
What causes Scania DTC 1025?
- Memory fault in the external amplifier. - Missing software in the external amplifier.
What are the symptoms?
The external amplifier is not responding to the software request.
How to fix Scania AMP fault code 1025?
- If the fault occurred during normal operation:
- Turn off the vehicle voltage with the starter key and then turn it on again.
- If the fault persists, renew the external amplifier.
- The control unit's internal memory has been damaged.
- If the error occurred while flashing the external amplifier, writing to the vehicle specification file or other activity with a connected computer:
- Perform a complete flash of the control unit.
- If the error occurs on a brand new control unit without installed software:
- Perform a complete flash of the control unit.
This information is for guidance only. Always follow the manufacturer workshop manual and safety procedures; if in doubt, contact an authorised workshop.
Code 1025 in other Scania systems
- 1025hex 0401 Fault in communication with the instrument cluster
- 1025hex 0401 Direct current converter (DCC) E84, CAN message missing
- 1025hex 0401 High supply voltage
- 1025hex 0401 Front grille panel sensor
- 1025hex 0401 Initiation of the forward looking camera
- 1025hex 000401 Internal fault in control unit
- 1025hex 0401 EGR content
- 1025hex 0401 EGR content
- 1025hex 0401 EGR content
- 1025hex 0401 EGR content
- 1025hex 0401 Internal fault
- 1025hex 0401 Starter key status, fault signal
- 1025hex 000401 CAN Sequence Error in message TSC1_10_C_PTO from COO
- 1025hex 0401 Supply voltage [V]
- 1025hex 0401 Supply voltage [V]
- 1025hex 0401 TCC control unit, fault in wastewater tank level sensor
- 1025hex 0401 Inverter E189, node A and gearbox control unit, inconsistent chassis serial number
- 1025hex 0401 Internal fault