Scania APS DTC 1896675 Voltage supply, sensor

APS Air Processing System · Scania · 2 variants

Code 1896675 (decimal). Some diagnostic tools show it in hexadecimal as 1CF0E3.

In short

The voltage to the pressure sensors for the rear service brake circuit and parking brake and trailer brake circuit is too high.

Variant 1

Applies to: APS2

What does Scania APS fault code 1896675 mean?

The voltage to the pressure sensors for the rear service brake circuit and parking brake and trailer brake circuit is too high.

What causes Scania DTC 1896675?

Fault in the control unit.

What are the symptoms?

The warning for a fault on the pressure regulator in the parking brake and trailer brake circuit is not working.

How to fix Scania APS fault code 1896675?

  1. Clear the fault code and check if it recurs.
  2. Renew the control unit and clear the fault code if the fault code recurs.

Variant 2

Applies to: APS2

Detection

The voltage to the pressure sensors for the rear service brake circuit and parking brake and trailer brake circuit is too high.

Possible cause

Fault in the control unit.

System reaction

The warning for a fault on the pressure regulator in the parking brake and trailer brake circuit is not working.

How to fix

  1. Clear the fault code and check if it recurs.
  2. If the fault code recurs, renew the control unit and clear the fault code.

This information is for guidance only. Always follow the manufacturer workshop manual and safety procedures; if in doubt, contact an authorised workshop.

Code 1896675 in other Scania systems