Scania APS DTC 82 Control unit

APS Air Processing System · Scania

Code 82 (decimal). Some diagnostic tools show it in hexadecimal as 0052.

In short

Incorrect data.

Applies to: APS1

What does Scania APS fault code 82 mean?

Incorrect data.

What causes Scania DTC 82?

Internal fault in the control unit.

How does the system react?

Yellow warning lamp comes on. The system works with limited functionality in one of the following ways: - The control unit uses pre-programmed values to control the compressor. Regeneration takes place after each load relief operation. - The system changes to working at reduced pressure.

How to fix Scania APS fault code 82?

  1. Clear the fault code.
  2. Turn off the power with the starter key.
  3. Wait for 60 seconds.
  4. Switch on the voltage with the starter key.
  5. If the fault code it still active, renew the control unit.

This information is for guidance only. Always follow the manufacturer workshop manual and safety procedures; if in doubt, contact an authorised workshop.

Code 82 in other Scania systems

Compare code 82 in every system →