Scania fault code 1314
Code 1314 is used by 9 different Scania systems. Choose the control unit shown in your diagnostic tool:
EMS Engine Management System
Oil pressure sensor T5
The voltage in the circuit has been lower than normal.
Read explanation →
TMS Transmission Management System
Solenoid valve for layshaft brake, short circuit
Short circuit to earth in the solenoid valve cable harness. The fault code is not set until the solenoid valve is activated.
Read explanation →
BMU Battery Management Unit
Insulation fault electric vehicle charging station
The CMP control unit (VCCU) has detected an insulation fault < 50 kohms to the connected electric vehicle charging station. Message sent to the BMU control unit.
Read explanation →
EMD
Oil pressure sensor T5
The voltage in the circuit has been lower than normal.
Read explanation →
EME
Oil pressure sensor T5/T4001
The voltage in the circuit has been lower than normal.
Read explanation →
EMO
Oil pressure sensor T5
The voltage in the circuit has been lower than normal.
Read explanation →
VDT
Internal fault
Internal fault in control unit E754.
Read explanation →
COO Coordinator
Short-range radar, right-hand side
Short-range radar on the right-hand side has limited functionality.
Read explanation →
PCS
L2 engage solenoid valve - Short to ground
Detected by HW.
Read explanation →