Scania fault code 1595
Code 1595 is used by 3 different Scania systems. Choose the control unit shown in your diagnostic tool:
EMS Engine Management System
Timeout for response message from alternator 1 on LIN bus.
Alternator 1 does not respond to requests from the master (EMS) within the required time.
Read explanation →
TMS Transmission Management System
Pressure sensor for EG power take-off 2, fault in voltage
The control unit has interpreted that there is a fault in the supply voltage to the pressure sensor.
Read explanation →
BMU Battery Management Unit
Propulsion battery, low capacity
The minimum capacity of the propulsion battery calculated on board is less than 80% of the capacity when the propulsion battery was new.
Read explanation →