Scania fault code 2049
Code 2049 is used by 4 different Scania systems. Choose the control unit shown in your diagnostic tool:
TMS Transmission Management System
Overheated clutch
Overheated clutch due to slippage.
Read explanation →
MBS
Convector by the driver, valve, failed calibration of end positions
Failed calibration of end positions. The resistance value is outside the approved values; 100-3,000 ohm for minimum position and 2,000-5,100 ohm for maximum position.
Read explanation →
ALM
Incorrect communication with the siren
ALM control unit E7 has detected a fault in LIN communication with siren N9.
Read explanation →
COMMUNICATOR Communicator (C200 / C300 / C400)
Internal battery
The voltage value of the internal battery in Scania Communicator is below the permitted level.
Read explanation →