Scania fault code 37

EMS Engine Management System Rail pessure actuator, data erratic, intermittent or incorrect in ECU ECU indicates that some fault detected in driver HW in ECU. Read explanation → VDT Rotational speed sensor Short circuit to battery. Read explanation → COO Coordinator High split The solenoid valve for high split has had an electric power consumption that is either above or below the permitted level. Read explanation → ELC Electronically controlled air suspension Solenoid valve for front axle, left-hand side Open circuit or current consumption too low in the circuit for the solenoid valve. Read explanation → ABS Anti-lock Braking System Wheel speed Break in the wheel circuit on the right-hand side of the front axle. Read explanation → CUV Visibility system Voltage supply The supply voltage to the control unit has exceeded 35V. Read explanation → LAS Locking and Alarm System Siren The communication between the siren and the alarm control unit does not function, probably due to conflicting PIN codes. Read explanation → ACS Articulation Control System End position sensor 1 ACS The end position sensor is activated even though vehicle speed is so high that the articulation unit should be relatively straight. Read explanation → AUS Audio System 12 V output 2, short circuit 12 V output 2 from the electronic control unit to the camera or other ancillary equipment, short circuit to supply voltage. Read explanation →