Scania TMS DTC 318 Electrical clutch actuator

Q: What does Scania TMS fault code 318 mean?

Electrical clutch actuator. Faults have been detected in the TMS control unit output signal. Code 318 (decimal). Some diagnostic tools show it in hexadecimal as 013E.

Q: How to fix Scania TMS fault code 318?

- Check the cable harness and connector between the TMS control unit (E5) and the clutch actuator (E93). - Renew the TMS control unit.

TMS Transmission Management System · Scania

Code 318 (decimal). Some diagnostic tools show it in hexadecimal as 013E.

In short

Faults have been detected in the TMS control unit output signal.

Applies to: TMS3 (TMS)

What does Scania TMS fault code 318 mean?

Faults have been detected in the TMS control unit output signal.

What causes Scania DTC 318?

Short circuit in the cable harness or connector. Fault in the TMS control unit.

How to fix Scania TMS fault code 318?

Check the cable harness and connector between the TMS control unit (E5) and the clutch actuator (E93).
Renew the TMS control unit.

This information is for guidance only. Always follow the manufacturer workshop manual and safety procedures; if in doubt, contact an authorised workshop.