Scania fault code 1281

EMS Engine Management System Cylinder 1, severe misfire Cylinder 1 misfires so much that there is a risk of damage to the catalytic converter. Read explanation → TMS Transmission Management System Solenoid valve for low splitter gear, short circuit Short circuit to earth in the solenoid valve cable harness. The fault code is only set when the solenoid valve is activated. Read explanation → BMU Battery Management Unit Coolant pump M38, internal fault in the propulsion battery cooling system The coolant pump indicates that it is hot or that it is inoperative. Read explanation → VDT Internal fault Internal memory fault in control unit E754. Read explanation → COO Coordinator The FLC control unit takes too long to start The start-up process for the control unit for the FLC forward looking camera system has taken too long, more than approximately 15 s. Read explanation → MBS Expansion unit A, internal fault The MBS control unit has detected faults in the voltage regulators or communication buses in Expansion unit A. Read explanation → OCS Relay for shut-off valves for vehicle gas on the high pressure side The circuit is open. Read explanation → PCS L1 disengage solenoid valve - Short to ground Detected by HW. Read explanation → LAS Locking and Alarm System Internal fault The LAS control unit is not configured correctly. Read explanation → ALM Control unit, internal fault Fault in the internal memory of ALM control unit. Read explanation → COMMUNICATOR Communicator (C200 / C300 / C400) Digital output 1 is short-circuited to ground The fault code is activated if digital output 1 is short-circuited to ground. A check is carried out each time the system is started. Read explanation → RTT Road Transport Informatics CAN data missing - No vehicle data is received in the software for the RTI unit. - Instruments in the software for the RTI unit are not working. Read explanation → SVIP CAN data missing - No vehicle data is received in the software for the RTI unit. - Instruments in the software for the RTI unit are not working. Read explanation →