Scania fault code 530

EBS Electronic Braking System Control unit Incorrect or unreliable data. Read explanation → COO Coordinator Clutch pedal sensor The voltage in the clutch pedal sensor circuit has been higher than permitted. The clutch pedal sensor generates 2 separate output signals. The fault applies to the redundant outpu… Read explanation → CUV Visibility system Windscreen wipers, low speed Windscreen wipers, low speed inoperative. Current consumption on the control unit output has fallen below 1.25 A for five seconds. Read explanation → BCI Communication with expansion units Open circuit in cable harness to the CAN bus for expansion units. Read explanation → LAS Locking and Alarm System Actuator, load hatch The actuator does not lock the cargo door. Read explanation → CMS Low power steering oil level warning The low power steering oil level sensor (T180) indicates that the level is too low. Read explanation → ALM Micro switch cargo area (truck)/micro switch A5 (bus), short circuit The micro switch is short-circuited to the voltage supply. Read explanation → APS Air Processing System Pressure sensor The voltage from the pressure sensor on the trailer and parking brake circuit has been outside permitted limits. Read explanation → ACS Articulation Control System End position sensor, open circuit The value of the articulation angle from the articulation angle sensor is outside the range of calibrated values for the left or right-hand end position with a margin of 150 mV wit… Read explanation → EST Solenoid valve for degraded mode Open circuit. Read explanation → ESTA Solenoid valve for degraded mode Open circuit. Read explanation →