Scania COO DTC 60 Electric power supply for sensor

COO Coordinator · Scania

Code 60 (decimal). Some diagnostic tools show it in hexadecimal as 003C.

In short

The coordinator supplies power internally to a number of analogue sensors. The fault code is generated if this voltage value has deviated from the permitted value.

Applies to: COO6 (COO6C)

What does Scania COO fault code 60 mean?

The coordinator supplies power internally to a number of analogue sensors. The fault code is generated if this voltage value has deviated from the permitted value.

What causes Scania DTC 60?

Short circuit or open circuit in one of the analogue sensors that are connected to the coordinator.

How does the system react?

The sensors with the affected circuits will probably be sending incorrect values to the coordinator.

How to fix Scania COO fault code 60?

  1. Check that there are no short circuits or open circuits in any of the affected sensor circuits.
  2. Measure on the following coordinator pins:
  3. On earlier models of coordinator: 69, 91, 93, 97, 98, 99 and 100.
  4. On later models of coordinator: B13, C28, C29, C30, C19 and C12.

This information is for guidance only. Always follow the manufacturer workshop manual and safety procedures; if in doubt, contact an authorised workshop.

Code 60 in other Scania systems

Compare code 60 in every system →