Variant 1
Applies to: ELC3
What does Scania ELC fault code 150 mean?
The voltage on the output to the solenoid valve has been too low.
What causes Scania DTC 150?
This fault code is generated if the solenoid valve and/or cable harness has been shorted to ground. This fault code can also be generated if there is a short circuit between two or more activated solenoid valves.
How does the system react?
If the fault occurs there will be no standby function, load transfer and manual raise/lower tag axle. The yellow warning symbol is on when the fault is active.
How to fix Scania ELC fault code 150?
Check the cable harness for damage and incorrect connections and make sure the solenoid valve is intact.
Variant 2
Applies to: ELC3 (ELC3Rear)
Detection
The voltage on the output to the solenoid valve has been too low.
Possible cause
This fault code is generated if the solenoid valve and/or cable harness has been shorted to ground. This fault code can also be generated if there is a short circuit between two or more activated solenoid valves.
System reaction
If the fault occurs there will be no standby function, load transfer and manual raise/lower tag axle. The yellow warning symbol is on when the fault is active.
How to fix
Check the cable harness for damage and incorrect connections and make sure the solenoid valve is intact.
This information is for guidance only. Always follow the manufacturer workshop manual and safety procedures; if in doubt, contact an authorised workshop.