Scania ELC DTC 357 Sensor signal from front axle pressure sensor.

ELC Electronically controlled air suspension · Scania

Code 357 (decimal). Some diagnostic tools show it in hexadecimal as 0165.

In short

The voltage on the input from the pressure sensor is between 0.15 V and 0.37 V.

Applies to: ELC3ELC3 (ELC3Rear)

What does Scania ELC fault code 357 mean?

The voltage on the input from the pressure sensor is between 0.15 V and 0.37 V.

What causes Scania DTC 357?

This fault code is generated if there is an open circuit in the cable harness or the pressure sensor itself.

How does the system react?

If the fault occurs there will be no standby function. The yellow warning symbol is on when the fault is active.

How to fix Scania ELC fault code 357?

  1. Check the cable harness for damage and loose connections and make sure the pressure sensor is intact.
  2. When the sensor is renewed, the control system must be calibrated using SDP3.

This information is for guidance only. Always follow the manufacturer workshop manual and safety procedures; if in doubt, contact an authorised workshop.

Code 357 in other Scania systems

Compare code 357 in every system →