Applies to: EMO2 (EMS)
What does Scania EMO fault code 629 mean?
The cylinder balancing compensation value has reached the minimum or maximum value for the cylinder. It is not possible to adjust the balancing value any further. The test is only run if: - there are no active electrical DTCs for coolant temperature sensor - engine is idling - coolant temperature is approximately 80 °C
What causes Scania DTC 629?
The cylinder gives different power than the other cylinders. This may be due to internal or external leakage in the injector, or defect control valve. Low compression may also lead to this DTC. The DTC can also arise due to air in the fuel system, caused for example by low fuel level or leakages in the supply circuit. In this case, probably more than one cylinder will be detected as defect.
How to fix Scania EMO fault code 629?
- Check the injectors.
- Check the cylinder compression.
This information is for guidance only. Always follow the manufacturer workshop manual and safety procedures; if in doubt, contact an authorised workshop.
Code 629 in other Scania systems
- 629hex 0275 Information fault, brake status
- 629hex 0275 Prohibited temperature in the propulsion battery E83
- 629hex 0275 Switch, vehicle level adjustment
- 629hex 0275 Dipped beam, right-hand side
- 629hex 0275 Cylinder balancing (min or max), cylinder 5
- 629hex 0275 Cylinder balancing (min or max), cylinder 5
- 629hex 0275 Cylinder balancing (min or max), cylinder 5
- 629hex 0275 Valve position sensor
- 629hex 0275 Valve position sensor
- 629hex 0275 Collision or fault in the collision detector
- 629hex 0275 Internal fault