Scania OCS DTC 67108 Charge air pressure sensor T122 downstream of the throttle

OCS OCS control unit · Scania

Code 67108 (decimal). Some diagnostic tools show it in hexadecimal as 010624.

In short

The value from the charge air pressure sensor is higher than the limit value.

Applies to: OCS1

What does Scania OCS fault code 67108 mean?

The value from the charge air pressure sensor is higher than the limit value.

What causes Scania DTC 67108?

Fault in the charge air pressure sensor, harness-to-harness connector or cable harness.

How does the system react?

The torque is limited. A yellow warning indication is displayed.

What are the symptoms?

The fault affects engine performance. Misfiring occurs. It is difficult to start the vehicle.

How to fix Scania OCS fault code 67108?

  1. Check the charge air pressure sensor and also the harness-to-component connectors and cable harness.
  2. Renew the charge air pressure sensor.
  3. Note: After clearing the fault codes the 15 voltage must be switched off for approximately 1 minute so that the pressure sensors adapt.

This information is for guidance only. Always follow the manufacturer workshop manual and safety procedures; if in doubt, contact an authorised workshop.

Code 67108 in other Scania systems