Scania OCS DTC 67584 Charge air pressure sensor T122 downstream of the throttle

OCS OCS control unit · Scania

Code 67584 (decimal). Some diagnostic tools show it in hexadecimal as 010800.

In short

Voltage in the charge air pressure sensor circuit is too high.

Applies to: OCS1

What does Scania OCS fault code 67584 mean?

Voltage in the charge air pressure sensor circuit is too high.

What causes Scania DTC 67584?

Fault in the charge air pressure sensor, harness-to-component connectors or cable harness.

How does the system react?

The torque is limited. A yellow warning indication is displayed.

What are the symptoms?

The fault affects engine performance. Misfiring occurs. It is difficult to start the vehicle.

How to fix Scania OCS fault code 67584?

  1. Check the charge air pressure sensor and also the harness-to-component connectors and cable harness.
  2. Renew the charge air pressure sensor.
  3. Note: After clearing the fault codes the 15 voltage must be switched off for approximately 1 minute so that the pressure sensors adapt.

This information is for guidance only. Always follow the manufacturer workshop manual and safety procedures; if in doubt, contact an authorised workshop.

Code 67584 in other Scania systems