Scania EMO DTC 519 Injector cyl. 7 cable/injector open load

EMO Блок управления EMO · Scania

Код 519 (десятичный). Некоторые диагностические приборы показывают его в шестнадцатеричном виде как 0207.

Кратко

Permanent open circuit detected on the injector coil(s) or the cabling to the injector(s). Faults detected only when engine is running.

Применяется к: EMO2 (EMS)

Что означает код неисправности Scania EMO 519?

Permanent open circuit detected on the injector coil(s) or the cabling to the injector(s). Faults detected only when engine is running.

Что вызывает код DTC 519 Scania?

Cables or injector connected to cylinder 7 malfunction. Probably the cable(s) or the coil(s) is broken.

Как реагирует система?

The system will continuously try to use the injectors regardless of malfunction. Gas engine: Torque is limited

Как устранить код неисправности Scania EMO 519?

  1. XPI engine: Disconnect connectors on the ECU and cables on the coil to the faulty injector(s).
  2. Measure resistance over coil; should be around 0.2 - 0.4 O.
  3. Check the cabling attachment to the ECU connector and through the cylinder head.
  4. Measure resistance between both ends of the high and low side of cables respectively (coil and ECU disconnected); there should be almost 0.0 O.
  5. Gas engine -Check injector for electrical fault -Check wiring -Replace injector After repair, restart engine to remove DTC

Эта информация предназначена только для справки. Всегда следуйте руководству по ремонту производителя и правилам техники безопасности; в случае сомнений обратитесь в авторизованную мастерскую.

Код 519 в других системах Scania

Сравнить код 519 во всех системах →