Scania MBS DTC 544 #Not implemented. Electrical error on CAN bus 4

MBS หน่วยควบคุม MBS · Scania

รหัส 544 (เลขฐานสิบ) เครื่องมือวินิจฉัยบางเครื่องแสดงเป็นเลขฐานสิบหกคือ 0220

สรุปสั้น ๆ

The CAN-controller of the CAN bus 4 has entered state bus-off, which indicates a communication error. There is a short circuit on the CAN bus 4.

ใช้ได้กับ: MBS3 (MBS)

รหัสข้อผิดพลาด Scania MBS 544 หมายความว่าอย่างไร?

The CAN-controller of the CAN bus 4 has entered state bus-off, which indicates a communication error. There is a short circuit on the CAN bus 4.

อะไรเป็นสาเหตุของรหัส DTC 544 ของ Scania?

• Defect wiring of CAN bus 4: - short circuit between CAN-high and CAN low. - short circuit between CAN-high and supply voltage. - short circuit between CAN-high and ground. - short circuit between CAN-low and supply voltage. - short circuit between CAN-low and ground. • Defect ECU unit(s) on the CAN bus 4.

ระบบมีปฏิกิริยาอย่างไร?

Functions dependent on information from CAN bus 4 are degraded, such as doors and the CCP.

มีอาการอย่างไรบ้าง?

Doors and CCP will not function as intended.

วิธีแก้ไขรหัสข้อผิดพลาด Scania MBS 544?

  1. The result of the receiving and transmitting messages is evaluated.
  2. Check connector CAN bus 4 on MBS.
  3. Check wiring for CAN bus 4:
  4. Measure the resistance (with the battery disconnected) between CAN-high and CAN-low.
  5. It should be close to 60 ohm (one 120 ohm termination resistor in each end of the CAN-bus).
  6. Measure the resistance (with the battery disconnected) between CAN-high on MBS and CAN-high on any other unit (e.g.
  7. MBS_x) on CAN bus 4.
  8. It should be close to zero ohm.
  9. Measure the resistance (with the battery disconnected) between CAN-low on MBS and CAN-low on any other unit on CAN bus 4.
  10. It should be close to zero ohm.

ข้อมูลนี้ใช้เป็นแนวทางเท่านั้น โปรดปฏิบัติตามคู่มือการซ่อมของผู้ผลิตและขั้นตอนความปลอดภัยเสมอ หากไม่แน่ใจ ให้ติดต่อศูนย์บริการที่ได้รับอนุญาต

รหัส 544 ในระบบอื่นของ Scania

เปรียบเทียบรหัส 544 ในทุกระบบ →