Applies to: ABS E
What does Scania ABS fault code 19 mean?
The control unit has detected DC voltage in the signal from the wheel on the left-hand side of the front axle.
What causes Scania DTC 19?
The wheel speed sensor or its wiring has been exposed to undesirable positive voltage through a short circuit.
How does the system react?
ABS, TC and hill hold function cease to function, if applicable. The warning lamp comes on.
How to fix Scania ABS fault code 19?
- Check the wheel speed sensor and its cabling.
- The voltage between circuit pin and ground must be 0 volt.
This information is for guidance only. Always follow the manufacturer workshop manual and safety procedures; if in doubt, contact an authorised workshop.
Code 19 in other Scania systems
- 19hex 0013 Communication with the EMS control unit
- 19hex 0013 Reference voltage
- 19hex 0013 Clutch pedal sensor
- 19hex 0013 CAN communication with the infotainment system (CUI)
- 19hex 0013 Radio signal
- 19hex 000013 Fault in 2 temperature sensors in the exhaust gas aftertreatment system.
- 19hex 0013 Extra sensor 2
- 19hex 0013 Front axle solenoid valve.
- 19hex 0013 Rotational speed sensor
- 19hex 0013 Windscreen washer