Applies to: CMS1 (CMS)
What does Scania CMS fault code 626 mean?
The signal from the instrument panel switch for load transfer is implausible. The signal has been active for more than 180 seconds.
What causes Scania DTC 626?
The fault may be due to: - The switch is stuck. - The switch or switch module is defective. - The switch module has sent corrupted information about switch status.
How does the system react?
The switch signal is ignored as long as the fault is active.
How to fix Scania CMS fault code 626?
Check the switch and the programmable switch module which is connected to the coordinator.
This information is for guidance only. Always follow the manufacturer workshop manual and safety procedures; if in doubt, contact an authorised workshop.
Code 626 in other Scania systems
- 626hex 0272 Fuel level, CAN communication fault
- 626hex 0272 Discharging the propulsion battery E83
- 626hex 0272 Dipped beam, right-hand side
- 626hex 0272 Cylinder balancing (min or max), cylinder 4
- 626hex 0272 Cylinder balancing (min or max), cylinder 4
- 626hex 0272 Cylinder 4 balancing min or max
- 626hex 0272 Cylinder balancing (min or max), cylinder 4
- 626hex 0272 Motor pump unit
- 626hex 0272 Motor pump unit
- 626hex 0272 Control unit
- 626hex 0272 Internal fault