Applies to: CMS1 (CMS)
What does Scania CMS fault code 627 mean?
The signal from the instrument panel switch for kneeling is implausible. The signal has been active for more than 180 seconds.
What causes Scania DTC 627?
The fault may be due to: - The switch is stuck. - The switch or switch module is defective. - The switch module has sent corrupted information about switch status.
How does the system react?
The switch signal is ignored as long as the fault is active.
How to fix Scania CMS fault code 627?
Check the switch and the programmable switch module which is connected to the coordinator.
This information is for guidance only. Always follow the manufacturer workshop manual and safety procedures; if in doubt, contact an authorised workshop.
Code 627 in other Scania systems
- 627hex 0273 Information fault, parking brake
- 627hex 0273 Propulsion battery, low state of charge
- 627hex 0273 Low split
- 627hex 0273 Main beam, right-hand side
- 627hex 0273 Injector, cylinder 5
- 627hex 0273 Motor pump unit
- 627hex 0273 Motor pump unit
- 627hex 0273 DCU control unit rear, fault in CAN communication
- 627hex 0273 Internal fault