Scania fault code 528

VDT Output signal Open circuit. Read explanation → COO Coordinator Clutch pedal sensor The voltage in the clutch pedal sensor circuit has been lower than permitted. The clutch pedal sensor generates 2 separate output signals. The fault applies to the redundant output… Read explanation → DDU Switch in the driver interaction control panel is stuck The signal from the switch indicates that it has been depressed for more than 60 seconds. Read explanation → CUV Visibility system Windscreen washer Current consumption on the control unit output has exceeded 5 A for one second. Read explanation → BCI Parking brake Conflicting signals from the 2 parking brake pressure sensors. Read explanation → LAS Locking and Alarm System Actuator, driver door The actuator does not lock the driver door. Read explanation → CMS Fuel level sensor The signal from the fuel level sensor (T16) is implausible; the voltage is too low. The fuel level sensor is short-circuited to ground. Read explanation → ALM Micro switch rear door passenger side (truck) / micro switch A4 (bus), short circuit The micro switch is short-circuited to earth. Read explanation → ACS Articulation Control System High supply voltage Voltage supply to the control unit is higher than permitted. Read explanation → ACSX High supply voltage Voltage supply to the control unit is higher than permitted. Read explanation →