Scania fault code 6
Code 6 is used by 16 different Scania systems. Choose the control unit shown in your diagnostic tool:
VDT
Rotational speed sensor
Implausible speed has been measured between the engine speed and the gearbox output speed.
Read explanation →
COO Coordinator
Communication with the EBS control unit
The communication between the coordinator and the EBS control unit has been interrupted.
Read explanation →
CUV Visibility system
Direction indicator front left.
The current consumption on the control unit output has exceeded 4 A.
Read explanation →
OPC Opticruise gearbox control
Control unit
Incorrect data.
Read explanation →
ICL Instrument Cluster
INFO button
The value for the voltage level in the INFO button circuit is implausible.
Read explanation →
ACC Automatic Climate Control
Water valve
The water valve does not reach the expected position. The water valve is jammed.
Read explanation →
DAS
Supply voltage too low
Supply voltage under 20 V.
Read explanation →
ACS Articulation Control System
Communication between the ACS control units
No communication between the ACS control units via the red CAN bus.
Read explanation →
RET Retarder
Control unit
Incorrect or unreliable data.
Read explanation →
AUS Audio System
Digital radio antenna, short circuit
Short circuit to ground.
Read explanation →
BCS
Control unit
Incorrect data.
Read explanation →
BWS
Communication with the instrument cluster
Communication between the bodywork control unit and instrument cluster has been interrupted.
Read explanation →
AMP
Loudspeaker channel 2, break in circuit
The AMP control unit has measured a voltage that indicates a break in the circuit.
Read explanation →
CTR
Switch for programming
The programming switch on the CTS unit is jammed.
Read explanation →
CTS
Switch on the operation unit
The short-stop cooling switch is stuck.
Read explanation →
DCP
LED-lamp, short-circuited
Short circuit.
Read explanation →