Scania fault code 833

EMS Engine Management System Camshaft position sensor T135 The signal from the camshaft position sensor deviates from the expected signal. Read explanation → BMU Battery Management Unit Insulation fault on external negative side The electrical insulation between the negative terminal and earth outside the propulsion battery is too low, lower than 4 kohm. Read explanation → EMD Camshaft position sensor T135 The camshaft position sensor indicates an incorrect value. Read explanation → EME Camshaft position sensor T135 The camshaft position sensor indicates an incorrect value. Read explanation → EMO Camshaft position sensor T135 The camshaft position sensor indicates an incorrect value. Read explanation → VDT Gearbox oil Gearbox oil level too low. Read explanation → COO Coordinator CAN communication with switch module Fault in communication with the switch module. Read explanation → MBS #Not implemented. Convector valve defective Feedback sensor is out of range or short circuit in flap control Read explanation → PCS CAN message missing The sequence check does not match the number of messages received. Read explanation → CMS Solenoid valve for tag axle lifting bellows, short circuit to battery Solenoid valve for tag axle lifting bellows, PWM output 4 (pin A18), is short-circuited to battery. Read explanation → DCC High temperature in direct current converter (DCC) The direct current converter sensor indicates a temperature of more than 90°C. Error messages about temperature being too high are sent across RES-CAN from the direct current conve… Read explanation →