Variant 1
Applies to: ELC3
What does Scania ELC fault code 115 mean?
The voltage on the output to the solenoid valve has been too high.
What causes Scania DTC 115?
This fault code is generated if the solenoid valve and/or cable harness has been exposed to undesired positive voltage, e.g. through a short circuit.
How does the system react?
If the fault occurs there will be no standby function, load transfer, raise/lower tag axle and automatic level correction. Only emergency functions work. The yellow warning symbol is on when the fault is active.
How to fix Scania ELC fault code 115?
Check the cable harness for damage or forbidden connections and make sure the solenoid valve is intact.
Variant 2
Applies to: ELC3 (ELC3Rear)
Detection
The voltage on the output to the solenoid valve has been too high.
Possible cause
This fault code is generated if the solenoid valve and/or cable harness has been exposed to undesired positive voltage, e.g. through a short circuit.
System reaction
If the fault occurs there will be no standby function, load transfer, raise/lower tag axle and automatic level correction. Only emergency functions work. The yellow warning symbol is on when the fault is active.
How to fix
Check the cable harness for damage or forbidden connections and make sure the solenoid valve is intact.
This information is for guidance only. Always follow the manufacturer workshop manual and safety procedures; if in doubt, contact an authorised workshop.