Scania EME DTC 513 Cylinder 1

EME EME control unit · Scania

Code 513 (decimal). Some diagnostic tools show it in hexadecimal as 0201.

In short

Open circuit detected in the injector solenoid valve or in the electrical cables to the injector.

Applies to: EME1

What does Scania EME fault code 513 mean?

Open circuit detected in the injector solenoid valve or in the electrical cables to the injector.

What causes Scania DTC 513?

The electrical cable or solenoid valve for the injector on cylinder 1 is probably defective.

What are the symptoms?

The fault only occurs when the engine is running. The control unit continuously tries to use the injectors irrespective of malfunctions. Engine power is affected to different degrees depending on how many injectors are faulty.

How to fix Scania EME fault code 513?

  1. Disconnect the electrical cable connections from the control unit and from the solenoid valve on the defective injector.
  2. Measure the resistance across the solenoid valve.
  3. Check the electrical cable pin connections in the control unit connector and the cable grommet in the cylinder head.
  4. Measure the resistance between the two loose ends of the positive and negative cables respectively.

This information is for guidance only. Always follow the manufacturer workshop manual and safety procedures; if in doubt, contact an authorised workshop.

Code 513 in other Scania systems

Compare code 513 in every system →