Scania APS DTC 1306860 Control unit

APS Air Processing System · Scania · 2 variants

Code 1306860 (decimal). Some diagnostic tools show it in hexadecimal as 13F0EC.

In short

There is no parameter value.

Variant 1

Applies to: APS2

What does Scania APS fault code 1306860 mean?

There is no parameter value.

What causes Scania DTC 1306860?

The control unit cannot read the parameter values correctly.

How does the system react?

The control unit uses standard settings instead of optimised settings while the fault is active.

How to fix Scania APS fault code 1306860?

  1. Clear the fault code.
  2. Turn off the voltage with the starter key.
  3. Wait for 30 seconds.
  4. Switch on the voltage with the starter key.
  5. If the fault code returns, renew the control unit.

Variant 2

Applies to: APS2

Detection

There is no parameter value.

Possible cause

The control unit cannot read the parameter values correctly.

System reaction

The control unit uses standard settings instead of optimised settings while the fault is active.

How to fix

  1. Clear the fault code.
  2. Turn off the power with the starter key.
  3. Wait for 30 seconds.
  4. Switch on the voltage with the starter key.
  5. If the fault code recurs, renew the control unit.

This information is for guidance only. Always follow the manufacturer workshop manual and safety procedures; if in doubt, contact an authorised workshop.