Scania fault code 11

EMS Engine Management System Control unit Incorrect or unreliable data. Read explanation → TMS Transmission Management System Control unit The checksum in the bootCom area is incorrect Read explanation → CUV Visibility system Front foglamp The current consumption on the control unit output has exceeded 12A. Read explanation → OPC Opticruise gearbox control Control unit The checksum in the bootCom area is incorrect Read explanation → ACC Automatic Climate Control Evaporator temperature sensor The evaporator temperature sensor value is outside its limits. Read explanation → DAS Fault in memory circuit Fault in SRAM. Read explanation → ACS Articulation Control System Switch, ACS The control unit registers a continuous signal from the end position stop disengagement switch when reversing. Read explanation → RET Retarder Control unit Incorrect or unreliable data. Read explanation → AUS Audio System Loudspeaker, short circuit Short circuit to ground in the mid-range speaker circuit in the front right-hand door. Short circuit to ground in the circuit for the right-hand tweeter. | Short circuit to ground… Read explanation → BCS Communication with the coordinator (COO) Communication with the coordinator (COO) has been terminated. Read explanation → BWS Neutral position sensor There was no signal with information about neutral position. Read explanation → AMP Loudspeaker channel 4, short circuit to earth The AMP control unit has measured a voltage that indicates a short circuit to earth. Read explanation → CTR Volume switch The volume switch on the CTS unit is jammed. Read explanation → CTS Switch on the operation unit The volume control switch is stuck. Read explanation →