Applies to: ACS5
What does Scania ACS fault code 11 mean?
The control unit registers a continuous signal from the end position stop disengagement switch when reversing.
What causes Scania DTC 11?
Defective switch. Short circuit or open circuit on the end position stop disengagement switch when reversing.
How does the system react?
It is not possible to disengage the end position stop while the fault code is active.
How to fix Scania ACS fault code 11?
- Check the switch.
- Check cable harness and connectors.
This information is for guidance only. Always follow the manufacturer workshop manual and safety procedures; if in doubt, contact an authorised workshop.
Code 11 in other Scania systems
- 11hex 00000B Loudspeaker channel 4, short circuit to earth
- 11hex 000B Loudspeaker, short circuit
- 11hex 000B Communication with the coordinator (COO)
- 11hex 000B Neutral position sensor
- 11hex 000B Evaporator temperature sensor
- 11hex 000B Switch on the operation unit
- 11hex 000B Volume switch
- 11hex 000B Fault in memory circuit
- 11hex 000B Control unit
- 11hex 000B Control unit
- 11hex 000B Control unit
- 11hex 000B Control unit
- 11hex 000B Front foglamp