Scania fault code 13

EMS Engine Management System Control unit Incorrect or unreliable data. Read explanation → TMS Transmission Management System Control unit The application is not running because the control unit has been requested by KWP to stay in boot mode. Read explanation → COO Coordinator Accelerator pedal sensor The voltage in the accelerator pedal sensor circuit has been either above or below the permitted level. The accelerator pedal sensor generates two separate output signals and the f… Read explanation → CUV Visibility system Reversing light relay The current consumption on the control unit output has been too high. Read explanation → OPC Opticruise gearbox control Control unit The application is not running because the control unit has been requested by KWP to stay in boot mode. Read explanation → ACC Automatic Climate Control Air temperature sensor The air temperature sensor value is outside its limits. Read explanation → ACS Articulation Control System Left pressure sensor, ACS The signal from the left pressure sensor is outside its range. Read explanation → RET Retarder Control unit Incorrect or unreliable data. Read explanation → AUS Audio System Loudspeaker, short circuit Short circuit to ground in the mid-range speaker circuit in the rear left-hand door. Short circuit to ground in the circuit for the left-hand mid-range speaker. | Short circuit to… Read explanation → BCS Communication with the electronic brake system (EBS) Communication with the electronic brake system (EBS) has been terminated. Read explanation → BWS Torque converter The bodywork control unit is not configured for the torque converter, but it receives signals from the torque converter. Read explanation → AMP Loudspeaker output signal, short circuit The external amplifier has detected a fault that indicates a short circuit between pins for the output signal to different loudspeakers. Read explanation → CTR OK switch The OK switch on the CTS unit is jammed. Read explanation → CTS Switch on the operation unit The OK function switch is stuck. Read explanation →