Scania fault code 529

VDT Output signal Invalid configuration. Read explanation → COO Coordinator Clutch pedal sensor The voltage in the clutch pedal sensor circuit has been higher than permitted. The clutch pedal sensor generates 2 separate output signals. The fault applies to the normal output s… Read explanation → CUV Visibility system Headlamp cleaning Current consumption on the control unit output has exceeded 5 A for one second. Read explanation → BCI Communication fault, external CAN bus Open circuit or short circuit to the external CAN bus. Read explanation → LAS Locking and Alarm System Actuator, passenger door The actuator does not lock the passenger door. Read explanation → ICL Instrument Cluster External instrument lighting Output PWM1 (external instrument panel lighting) for the instrument cluster is short circuited to voltage. The instrument cluster indicates excessive electric power supply when the… Read explanation → CMS Fuel level sensor The signal from the fuel level sensor (T16) is implausible; the voltage is too high. The fuel level sensor circuit is broken or short-circuited to voltage supply. Read explanation → ALM Micro switch rear door passenger side (truck)/micro switch A4 (bus), open circuit Open circuit in the micro switch. Read explanation → ACS Articulation Control System ACS control unit, loss of earth The ACS control unit has detected that the voltage to earthing pin A3 or A1 is displaying an implausible value. Read explanation → EST Solenoid valve for operating mode The fault code is activated when the system detects a higher or lower current than expected in the circuit. Read explanation → ESTA Solenoid valve for operating mode The fault code is activated when the system detects a higher or lower current than expected in the circuit. Read explanation → ACSX ACS control unit, loss of earth The ACS control unit has detected that the voltage to earthing pin A3 or A1 is displaying an implausible value. Read explanation →