Scania fault code 560
Code 560 is used by 9 different Scania systems. Choose the control unit shown in your diagnostic tool:
BMU Battery Management Unit
Electrical fault on RES SUB CAN
Short circuit on CAN between BMU and IBU.
Read explanation →
COO Coordinator
Communication with the APS control unit
No CAN messages from the APS control unit.
Read explanation →
MBS
MBS expansion unit A, fault in CAN communication
CAN communication with MBS expansion unit A interrupted or missing.
Read explanation →
BCI
BIC program
The BIC program has reduced functionality because a pin or signal used in the program is being interpreted incorrectly.
Read explanation →
ACS Articulation Control System
CAN Communication with the coordinator (COO)
No CAN messages from the coordinator.
Read explanation →
EST
Steering angle sensor
The CAN message relating to the steering angle sensor value is incorrect.
Read explanation →
ESTA
Steering angle sensor
The CAN message relating to the steering angle sensor value is incorrect.
Read explanation →
DCU
Electric door motor, rear door leaf, open circuit, output
A current below the normal operating level has been detected on one of the 2 outputs (CN1-13 and CN1-16) on the H-bridge that drives the door electric motor.
Read explanation →
ACSX
CAN Communication with the coordinator (COO)
No CAN messages from the coordinator.
Read explanation →