Scania fault code 8

TMS Transmission Management System Control unit Incorrect or unreliable data. Read explanation → VDT Rotational speed sensor Fault in the signal or poor signal quality. Measured pulse varies more than is permitted. Read explanation → COO Coordinator Communication with the instrument cluster The communication between the coordinator and the instrument cluster has been interrupted. Read explanation → CUV Visibility system Direction indicator rear left. The current consumption on the control unit output has exceeded 8.5 A. Read explanation → OPC Opticruise gearbox control Control unit Incorrect or unreliable data. Read explanation → ACC Automatic Climate Control Auxiliary heater The output signal from the auxiliary heater is short circuited to positive supply or ground, or the circuit is open. Read explanation → ACS Articulation Control System End position sensor and angle sensor, ACS Signals from end position sensor and angle sensor do not agree. Read explanation → RET Retarder Control unit Incorrect or unreliable data. Read explanation → AWD All-Wheel Drive Control unit Incorrect or unreliable data. Read explanation → AUS Audio System Loudspeaker, short circuit Short circuit to voltage supply in the circuit to the mid-range loudspeaker in the front left-hand door. Short circuit to voltage supply in the circuit to the left-hand tweeter. |… Read explanation → BCS Communication with the lilac CAN bus No communication on the lilac CAN bus. Read explanation → BWS Communication with the APS control unit Communication between the bodywork control unit and the APS control unit has been interrupted. Read explanation → AMP Loudspeaker channel 3, short circuit to earth The AMP control unit has measured a voltage that indicates a short circuit to earth. Read explanation → CTR Switch for sleep-in function The automatic "sleep in" switch on the CTS unit is jammed. Read explanation → CTS Switch on the operation unit The snooze function switch is stuck. Read explanation → DCP Internal fault, missing UART message Missing UART message. Read explanation →