Applies to: CUV2CUV3 (VIS)
What does Scania CUV fault code 518 mean?
Spare parts programming parameters have been lost. The file containing the parameters is incomplete or missing. Spare parts programming parameters could not be read from the memory.
What causes Scania DTC 518?
The system 30 voltage was disconnected while the control unit was writing the file containing the spare parts programming parameters.
How to fix Scania CUV fault code 518?
Spare parts program CUV.
This information is for guidance only. Always follow the manufacturer workshop manual and safety procedures; if in doubt, contact an authorised workshop.
Code 518 in other Scania systems
- 518hex 0206 Parameter configuration
- 518hex 0206 Parameter configuration
- 518hex 0206 Micro switch rear door driver's side (truck)/micro switch A3 (bus), short circuit
- 518hex 0206 Control unit, parameter setting
- 518hex 0206 Control unit
- 518hex 0206 Function parameters missing
- 518hex 0206 Setting parameters
- 518hex 0206 Fuel level
- 518hex 0206 Control unit parameter setting
- 518hex 0206 Cylinder 6
- 518hex 0206 Cylinder 6
- 518hex 0206 Cylinder 6
- 518hex 0206 Cylinder 6
- 518hex 0206 Control unit
- 518hex 0206 Control unit
- 518hex 0206 Motion sensor in bodywork
- 518hex 0206 Control unit parameter setting
- 518hex 0206 TCC control unit, missing parameters
- 518hex 0206 Manual downshifting, CAN message fault
- 518hex 0206 Output signal