Applies to: EST1 (EST)
What does Scania EST fault code 518 mean?
The system has no configuration.
What causes Scania DTC 518?
- Interference in the voltage supply to the control unit when the configuration was saved.
How to fix Scania EST fault code 518?
Carry out spare parts programming on the control unit.
This information is for guidance only. Always follow the manufacturer workshop manual and safety procedures; if in doubt, contact an authorised workshop.
Code 518 in other Scania systems
- 518hex 0206 Parameter configuration
- 518hex 0206 Parameter configuration
- 518hex 0206 Micro switch rear door driver's side (truck)/micro switch A3 (bus), short circuit
- 518hex 0206 Control unit, parameter setting
- 518hex 0206 Control unit
- 518hex 0206 Function parameters missing
- 518hex 0206 Setting parameters
- 518hex 0206 Fuel level
- 518hex 0206 Control unit
- 518hex 0206 Control unit parameter setting
- 518hex 0206 Cylinder 6
- 518hex 0206 Cylinder 6
- 518hex 0206 Cylinder 6
- 518hex 0206 Cylinder 6
- 518hex 0206 Control unit
- 518hex 0206 Motion sensor in bodywork
- 518hex 0206 Control unit parameter setting
- 518hex 0206 TCC control unit, missing parameters
- 518hex 0206 Manual downshifting, CAN message fault
- 518hex 0206 Output signal