Variant 1
Applies to: CUV2
What does Scania CUV fault code 517 mean?
Stored operational data has been lost. The file containing operational data was incomplete or missing when the control unit started. Stored operational data could not be read from the memory.
What causes Scania DTC 517?
The system 30 voltage was disconnected while the control unit was writing the file containing the operational data.
How does the system react?
There is no operational data.
How to fix Scania CUV fault code 517?
No action because lost operational data cannot be recreated.
Variant 2
Applies to: CUV3 (VIS)
Detection
Stored operational data has been lost. The file containing operational data was incomplete or missing when the control unit started. Stored operational data could not be read from the memory.
Possible cause
The system 30 voltage was interrupted while the control unit was writing to the file containing operational data.
Symptoms
There is no operational data.
How to fix
No action because lost operational data cannot be recreated.
This information is for guidance only. Always follow the manufacturer workshop manual and safety procedures; if in doubt, contact an authorised workshop.
Code 517 in other Scania systems
- 517hex 0205 Operational data
- 517hex 0205 Operational data
- 517hex 0205 Micro switch door lock passenger side (truck)/micro switch A2 (bus), open circuit
- 517hex 0205 Control unit, operational data
- 517hex 0205 Control unit
- 517hex 0205 Operational data missing
- 517hex 0205 Operational data
- 517hex 0205 Accelerator pedal sensor
- 517hex 0205 Cylinder 5
- 517hex 0205 Cylinder 5
- 517hex 0205 Cylinder 5
- 517hex 0205 Cylinder 5
- 517hex 0205 Control unit
- 517hex 0205 Control unit
- 517hex 0205 Control unit
- 517hex 0205 Motion sensor in bodywork
- 517hex 0205 #Not implemented. Operation data stored in the persistent memory has been lost.
- 517hex 0205 TCC control unit, operational data fault
- 517hex 0205 Power transmission check, no CAN message
- 517hex 0205 Output signal