Scania fault code 806

EMS Engine Management System Knock sensor Knock sensor 1 produces deviating value. Read explanation → BMU Battery Management Unit The level monitor for the inverter E82 (MGU) and direct current converter E84 (DCC) is defective The level monitor for the inverter and direct current converter cooling system is defective. Discovered through the response from the level monitor. Read explanation → COO Coordinator Steering angle sensor Fault in the CAN communication with the steering angle sensor. Read explanation → MBS Primary passenger area evaporator, ice formation. - The evaporator temperature has dropped too low. - The air flow is limited. Read explanation → ELC Electronically controlled air suspension Control box 2 The voltage on the input from the control box has been too low. Read explanation → DDU Missing CAN-messages from AVM-system EOL CAMERA_PORT1_POSITION =0x04: AVM OR EOL CAMERA_PORT3_POSITION =0x04: AVM Fault code set when the Diagnostic Message 1 (NM_AVM.NM_State_AVM) from AVM is timed out 2 second start… Read explanation → CMS Brake switch Fault in CAN signals dependent on the brake switch. Read explanation → DAS Steering angle sensor Fault in CAN communication with the steering angle sensor. Read explanation → DCU Power supply pin group V1, voltage too low The door control unit has detected that the voltage from power supply pin group V1 is too low, below 5 V. Read explanation →