Applies to: MBS3 (MBS)
What does Scania MBS fault code 512 mean?
The control unit has detected an internal memory fault.
What causes Scania DTC 512?
- System malfunction. - Fault in the control unit software. - Fault in the control unit hardware.
How does the system react?
The electronic control unit (ECU) may, under certain conditions, perform a software reset of the control unit.
What are the symptoms?
When the main body system is restarted, some buttons and the ceiling lighting stop working.
How to fix Scania MBS fault code 512?
- Replace the control unit.
This information is for guidance only. Always follow the manufacturer workshop manual and safety procedures; if in doubt, contact an authorised workshop.
Code 512 in other Scania systems
- 512hex 0200 Control unit
- 512hex 0200 Control unit
- 512hex 0200 Micro switch door lock driver's side (truck)/micro switch A1 (bus), short circuit
- 512hex 0200 Expansion unit, internal memory
- 512hex 0200 Error in the ECU hardware memory
- 512hex 0200 Control unit, internal memory
- 512hex 0200 Accelerator pedal sensor
- 512hex 0200 Control unit
- 512hex 0200 Door control unit, internal fault
- 512hex 000200 Switch on steering wheel, pressed for 60 seconds
- 512hex 000200 Fuel temperature sensor, short circuit to battery or open circuit
- 512hex 0200 Control unit
- 512hex 0200 Control unit
- 512hex 0200 Button panel, steering wheel
- 512hex 0200 Internal software fault
- 512hex 0200 Digital tachograph card
- 512hex 0200 The TCC control unit, fault in internal memory
- 512hex 0200 Accelerator pedal position, CAN message fault
- 512hex 0200 Output signal