Scania fault code 514

EMS Engine Management System Cylinder 2 The engine control unit has detected an abnormal voltage, indicating a break in the circuit. Read explanation → TMS Transmission Management System Accelerator pedal switch for low idling, CAN message fault. The control unit indicates a signalling fault in the accelerator pedal switch for low idling. Read explanation → BMU Battery Management Unit Overloaded software Overload in the control unit processor or memory detected. The system carries out regular load checks of the control unit processor and memory usage. - Memory usage > 85%. - Contro… Read explanation → EMD Cylinder 2 Open circuit detected in the injector solenoid valve or in the electrical cables to the injector. Read explanation → EME Cylinder 2 Open circuit detected in the injector solenoid valve or in the electrical cables to the injector. Read explanation → EMO Cylinder 2 Open circuit detected in the injector solenoid valve or in the electrical cables to the injector. Read explanation → COO Coordinator Accelerator pedal sensor The voltage in the accelerator pedal sensor circuit has been above the permitted level. The accelerator pedal sensor generates two separate output signals. The fault applies to the… Read explanation → MBS MBS control unit, overloaded software Overloading of the control unit's processor has been detected. Read explanation → CUV Visibility system Control unit Overloaded data processes or internal memory. Read explanation → BCI Expansion unit, overload in CPU Overload in CPU or internal memory. Read explanation → LAS Locking and Alarm System Motion sensor in the cab The cab motion sensor has no communication with control unit pin C2. Read explanation → CMS Control unit, Internal fault Unexpected or prohibited event in the control unit. Read explanation → ALM Micro switch door lock driver's side (truck)/micro switch A1 (bus), open circuit Open circuit in the micro switch. Read explanation → APS Air Processing System Pressure sensor The voltage from the pressure sensor on the front circuit has been outside permitted limits. Read explanation → ACS Articulation Control System Control unit Internal overloading. Read explanation → EST Control unit Processor or memory is overloaded. Read explanation → ESTA Control unit Processor or memory is overloaded. Read explanation → TCC TCC control unit, overloaded software Overload in the control unit or its software detected. Read explanation → COMMUNICATOR Communicator (C200 / C300 / C400) GPS antenna overloaded The fault code is activated when the connection between the GPS module and the GPS antenna has been interrupted for more than 25 seconds. Read explanation → DCU Door control unit, overload Overload in CPU or internal memory detected. Read explanation → ACSX Control unit Internal overloading. Read explanation → RTT Road Transport Informatics PIN code or SIM card The GSM telephone is not working. The text "no PIN" is displayed in the telephone view. Read explanation → SVIP PIN code or SIM card The GSM telephone is not working. The text "no PIN" is displayed in the telephone view. Read explanation →