Scania EMD DTC 519 Cylinder 7

EMD EMD control unit · Scania · 2 variants

Code 519 (decimal). Some diagnostic tools show it in hexadecimal as 0207.

In short

Open circuit detected in the injector solenoid valve or in the electrical cables to the injector.

Variant 1

Applies to: EMD0

What does Scania EMD fault code 519 mean?

Open circuit detected in the injector solenoid valve or in the electrical cables to the injector.

What causes Scania DTC 519?

The electrical cable or solenoid valve for the injector on cylinder 7 is probably defective.

What are the symptoms?

The fault only occurs when the engine is running. The control unit continuously tries to use the injectors irrespective of malfunctions. Engine power is affected to different degrees depending on how many injectors are faulty.

How to fix Scania EMD fault code 519?

  1. Run Safety precautions for the fuel system.
  2. Disconnect the electrical cable connections from the control unit and from the solenoid valve on the defective injector.
  3. Measure the resistance across the solenoid valve.
  4. Check the electrical cable pin connections in the switch to the control unit and the cable grommet in the cylinder head.
  5. Measure the resistance between the two loose ends of the positive cable and the negative cable.
  6. If the operating time since the fault code was generated exceeds 10 hours, drain the EGR cooler as there is a risk that condensation formed in the air-cooled EGR cooler while the EGR system was switched off.
  7. Drain according to the instructions in Workshop Manual, subgroup 01-65.

Variant 2

Applies to: EMD1

Detection

Open circuit detected in the injector solenoid valve or in the electrical cables to the injector.

Possible cause

The electrical cable or solenoid valve for the injector on cylinder 7 is probably defective.

Symptoms

The fault only occurs when the engine is running. The control unit continuously tries to use the injectors irrespective of malfunctions. Engine power is affected to different degrees depending on how many injectors are faulty.

How to fix

  1. Run Safety precautions for the fuel system.
  2. Disconnect the electrical cable connections from the control unit and from the solenoid valve on the defective injector.
  3. Measure the resistance across the solenoid valve.
  4. Check the electrical cable pin connections in the switch to the control unit and the cable grommet in the cylinder head.
  5. Measure the resistance between the two loose ends of the positive cable and the negative cable.
  6. If the operating time since the fault code was generated exceeds 10 hours, drain the EGR cooler as there is a risk that condensation forms in the air-cooled EGR cooler when the EGR system has been switched off.
  7. Drain according to the instructions in Workshop Manual, subgroup 01-65.

This information is for guidance only. Always follow the manufacturer workshop manual and safety procedures; if in doubt, contact an authorised workshop.

Code 519 in other Scania systems

Compare code 519 in every system →