Scania fault code 519

EMS Engine Management System Injector cyl. 7 cable/injector open load The engine control unit has detected an abnormal voltage, indicating a break in the circuit. Read explanation → TMS Transmission Management System Manual changing into higher gears, CAN message fault The control unit indicates a signalling fault in the gear lever switch when manually changing into higher gears. Read explanation → BMU Battery Management Unit Electrical fault on TMS-SUB-CAN CAN communication fault. No message between TMS and BMU. Read explanation → EMD Cylinder 7 Open circuit detected in the injector solenoid valve or in the electrical cables to the injector. Read explanation → EME Cylinder 7 Open circuit detected in the injector solenoid valve or in the electrical cables to the injector. Read explanation → EMO Injector cyl. 7 cable/injector open load Permanent open circuit detected on the injector coil(s) or the cabling to the injector(s). Faults detected only when engine is running. Read explanation → MBS Not in use Communication error. The CAN-controller of the Blue CAN-bus has entered state bus-off. There might be a short circuit on the Blue CAN-bus Read explanation → CUV Visibility system CAN communication fault Yellow CAN bus has short circuited. Read explanation → BCI Defective ID pin connection. The connection to the expansion unit ID pin was defective at startup, or the connection has been disturbed whilst running. Read explanation → LAS Locking and Alarm System Motion sensor in bodywork The bodywork motion sensor has no communication with control unit pin C4. Read explanation → ALM Micro switch rear door driver's side (truck) / micro switch A3 (bus), short circuit The micro switch is short-circuited to earth. Read explanation → EST Control unit Internal fault. Read explanation → ESTA Control unit Internal fault. Read explanation →