Scania fault code 17

EMS Engine Management System Cam phaser for intake valve, position fault Intake valve cam phaser cannot hold the reference position. Read explanation → VDT Rotational speed sensor Open circuit. Read explanation → COO Coordinator Brake pedal sensor The voltage in the brake pedal sensor circuit has been either above or below the permitted level. The brake pedal sensor generates two separate output signals. The fault applies to… Read explanation → ABS Anti-lock Braking System Wheel speed Low signal strength from the wheel on the left-hand side of the front axle. Read explanation → CUV Visibility system Work lamps/daytime running lights The control unit input has been short circuited to 24 V for more than five seconds. Read explanation → LAS Locking and Alarm System Front grille panel sensor The voltage on the alarm control unit input has been below 3 V. Read explanation → DIS Low supply voltage The supply voltage is below 9.5 V. Read explanation → ACS Articulation Control System Left-hand damping cylinder, ACS The oil pressure in the left-hand damping cylinder deviates from the expected value. The expected pressure is calculated using the left-hand pressure sensor and the articulation an… Read explanation → AUS Audio System Central mid-range speaker, short circuit Short circuit to ground in the loudspeaker circuit. Read explanation → BWS No CAN message Fault on the CAN communication on the external CAN bus. Read explanation → CTR CTS unit Fault in the signal from the ACC, Automatic climate system to the CTS unit. Read explanation →