Scania fault code 22

EMS Engine Management System Control unit Incorrect or unreliable data. Read explanation → EMD Camshaft position sensor T135 The crankshaft sensor registers that the engine is rotating, but the camshaft position sensor generates no pulses. Read explanation → EME Camshaft position sensor T135 The crankshaft sensor registers that the engine is rotating, but the camshaft position sensor generates no pulses. Read explanation → EMO Camshaft position sensor T135 The crankshaft sensor registers that the engine is rotating, but the camshaft position sensor generates no pulses. Read explanation → VDT Rotational speed sensor Short circuit to ground. Read explanation → COO Coordinator Green CAN bus All communication on the green CAN bus is interrupted. Read explanation → ELC Electronically controlled air suspension Front axle solenoid valve. The voltage on the output to the solenoid valve has been too low. Read explanation → ABS Anti-lock Braking System Wheel speed Short circuit in the wheel circuit on the left-hand side of the front axle. Read explanation → CUV Visibility system Horn. The current consumption on the control unit output has exceeded 5A. Read explanation → ACC Automatic Climate Control Aspirator fan The aspirator fan does not work. Read explanation → DIS The radar is incorrectly aligned The radar is not aligned with the vehicle direction. Read explanation → ACS Articulation Control System Communication with the COO control unit Signal from the coordinator missing. Read explanation → AUS Audio System AUX input in instrument panel, short circuit Short circuit to supply voltage. Read explanation → BCS Brake pressure sensor The tag axle brake pressure sensor may be defective or the signal voltage has been outside permitted limits. The brake pressure sensor voltage level may have been too high or too l… Read explanation → CTR Communication with the heater Missing response from the heater. Read explanation →