Scania fault code 777

EMS Engine Management System Steering wheel switch for cruise control, CAN messages missing Read explanation → BMU Battery Management Unit Incorrect behaviour of the coolant pump in the direct current converter E84 (DCC) and inverter E82 (MGU) cooling system The coolant pump of the direct current converter and inverter cooling system does not respond correctly to a request. The rotational speed of the coolant pump for the direct curren… Read explanation → COO Coordinator CAN bus for driver support All communication on the CAN bus is interrupted. Read explanation → MBS Sensor for engine compartment door, right-hand, open circuit The voltage supply to the control unit input for the right engine compartment hatch sensor is 12 V. This indicates an open circuit. Read explanation → DDU CAN messages are missing from CAN bus 2 The DDU control unit has not received any CAN messages. The fault code is only set if the 15 voltage is on. Read explanation → ICL Instrument Cluster Communication with electronic chassis level control (ELC) for articulated bus No can messages from the suspension management system that regulates the rear section of the bus. Read explanation → CMS Fuel theft alarm Information on the alarm status is missing or has been implausible for over 10 minutes. Read explanation → DAS CAN bus for short-range radar, right All communication on the CAN bus has been interrupted. Read explanation → COMMUNICATOR Communicator (C200 / C300 / C400) Communication with the bodywork system (BWE) The RTC control unit has not received any CAN messages from the BWE control unit within the time expected. Read explanation → DCU Sensing strip, front or single door leaf, open circuit - An open circuit has been detected on the input (CN3-11) for the sensing strip. - The door control unit has measured a resistance on the sensing strip higher than approx. 12,000 o… Read explanation →