Scania fault code 515

EMS Engine Management System Cylinder 3 The engine control unit has detected an abnormal voltage, indicating a break in the circuit. Read explanation → TMS Transmission Management System Changed gear, CAN message fault The control unit indicates a signalling fault during a request to shift gear from the gear lever. Read explanation → BMU Battery Management Unit Inconsistent storage of RAM information The memory which stores information on configuration is inconsistent. A part of the internal RAM memory is used to store information on configuration. At system start compressed in… Read explanation → EMD Cylinder 3 Open circuit detected in the injector solenoid valve or in the electrical cables to the injector. Read explanation → EME Cylinder 3 Open circuit detected in the injector solenoid valve or in the electrical cables to the injector. Read explanation → EMO Cylinder 3 Open circuit detected in the injector solenoid valve or in the electrical cables to the injector. Read explanation → VDT Output signal Short circuit to ground on output for control unit E754. Read explanation → COO Coordinator Accelerator pedal sensor The voltage in the accelerator pedal sensor circuit has been below the permitted level. The accelerator pedal sensor generates two separate output signals and the fault applies to… Read explanation → MBS RAM memory, inconsistent The memory for the configurations is not reliable. Read explanation → CUV Visibility system Control unit Memory used to store configuration data is inconsistent. Read explanation → BCI Expansion unit, internal memory Fault in data stored in expansion unit internal memory. Read explanation → LAS Locking and Alarm System Motion sensor in the cab The cab motion sensor has no communication with control unit pin C2. Read explanation → CMS Control unit, internal memory Fault in data stored in the control unit internal memory. Read explanation → ALM Micro switch door lock passenger side (truck)/micro switch A2 (bus), short circuit The micro switch is short-circuited to the voltage supply. Read explanation → ACS Articulation Control System Control unit Internal memory fault. Read explanation → EST Control unit The system was started with an incorrect configuration. Read explanation → ESTA Control unit The system was started with an incorrect configuration. Read explanation → TCC TCC control unit, fault in long-term memory The memory for storing configuration data has changed. Read explanation → COMMUNICATOR Communicator (C200 / C300 / C400) No GPS position The GPS module in Scania Communicator is not reporting any positioning for the vehicle. Read explanation → DCU RAM, internal memory fault The control unit has detected an internal memory fault. Read explanation → ACSX Control unit Internal memory fault. Read explanation → RTT Road Transport Informatics GSM module The GSM telephone is not working. The text "No service" is displayed in the telephone view. Read explanation → SVIP GSM module The GSM telephone is not working. The text "No service" is displayed in the telephone view. Read explanation →