Scania fault code 9

EMS Engine Management System Cold start intake cam phaser target error Intake phaser not able to hold reference position Read explanation → VDT Rotational speed sensor Open circuit. Read explanation → COO Coordinator Signals from the starter lock Inadmissible combination of signals to the coordinator from the starter lock. The fault code is generated when the coordinator receives a signal indicating that the voltage is turn… Read explanation → CUV Visibility system Direction indicators on trailer, right. The current consumption on the control unit output has exceeded 8.5 A. Read explanation → ACC Automatic Climate Control Roof hatch The output signal from the roof hatch is short circuited to positive supply. Read explanation → ACS Articulation Control System Angle sensor, ACS The signal from the angle sensor is outside its range. Read explanation → RET Retarder Control unit Incorrect or unreliable data. Read explanation → AUS Audio System Loudspeaker, short circuit Short circuit to ground in the circuit to the mid-range speaker in the front left-hand door. Short circuit to ground in the circuit to the left-hand tweeter. | Short circuit to gro… Read explanation → BCS Communication with the articulation control system (ACS) Communication with the articulation control system (ACS) has been terminated. Read explanation → BWS Parking brake signal No extra parking brake signal from the coordinator. Read explanation → AMP Loudspeaker channel 3, break in circuit The AMP control unit has measured a voltage that indicates a break in the circuit. Read explanation → CTR CD switch The CD switch on the CTS unit is jammed. Read explanation → CTS Switch on the operation unit The infotainment system switch is stuck. Read explanation → DCP Too great a difference between 30 voltage and wake-up signal Potential between 30 voltage and wake-up signal (15 voltage) is more than 10.6 V. Read explanation →